Hitachi 13VR10B - Manual (Page 36)

SPECIAL PLAYBACK
36
REPEAT PLAYBACK
The TV/VCR has an auto repeat function that allows you to repeat a tape
indefinitely without using the PLAY button. There are two selections for Auto
Repeat Playback.
ALL REPEAT: repeat playback from the beginning to the end of the tape.
BLANK REPEAT: repeat playback from the beginning to the blank part,
which has no more than 10 seconds, of recorded information.
NOTE: No buttons except POWER and STOP buttons will work during Repeat
Playback. Always set the Repeat Playback to [OFF] when this function is not
being used.
1 Select "USER'S SET UP"
Press MENU button repeatedly to point to "USER'S SET UP".
Then, press SELECT button.
2 Select "ALL" or "BLANK"
Press MENU button repeatedly to point to 'REPEAT PLAY".
Press CH
or button repeatedly until your desired selection [ALL] or
[BLANK] appears.
3 Exit the Repeat Play setting
Press MENU button repeatedly until the TV/VCR returns to the TV mode.
4 Start Playback
Press PLAY button to start the Repeat Play. "REPEAT PLAY " appears.
• Once you select the Repeat Play mode, it stays in effect even after you turn
off the TV/VCR.
• If the Rental mode is set to [ON], the "RENTAL PLAY " display has priority.
TO CANCEL THE REPEAT PLAY MODE
Press STOP button to stop playback. Repeat steps [1], then follow step [2]
but select [OFF]. Press MENU button repeatedly until the TV/VCR returns to
the TV mode.