Hitachi DH 38YE - Manual (Page 14)

English
14
3. Extension cord
When the work area is far away from the power source, use an extension cord of sufficient
thickness and rated capacity. The extension cord should be kept as short as practicable.
WARNING:
Damaged cord must be replaced or repaired.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact
a licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a serious hazard.
5. Confirming condition of the environment:
Confirm that the work site is placed under appropriate conditions conforming to
prescribed precautions.
6. How to install dust cover (Fig. 2)
Always install the dust cover on the drill bit or
the taper shank adaptor. Insert the dust cover
until it lies flush in the groove.
NOTE: For a thick drill bit, insert the dust cover
from drill rear.
7. How to install tool
CAUTION: For tools such as a bull point and a
cold chisel, use only Hitachi
genuine parts.
(1) Clean, then smear the tool shank with the
grease provided.
(2) Pull the tool holder in the direction of arrow 1
and rotate it in the direction of arrow 2
(counterclockwise). Fully insert the tool shank
into the hexagonal hole of the front cover.
(Fig. 3)
(3) Return the tool holder to fix the tool.
NOTE: Remove in the reverse order to
installation.
Dust cover
Fig. 2
Insert up to the groove
Front Cover
Tool Shank
Fig. 3
Tool Holder