Honeywell EQUIP HD3MDIHX - Manual (Page 24)

24
Installation and Setup
Mounting the Camera
Surface Mount
1. Secure the skirt to the ceiling (hardware
not supplied) or to the wall using the
supplied screws.
Note You must use screws that are able to
support at least three times the weight
of the camera.
2. Connect the wires (see Connecting the
Wires on page 19 ).
3. Rotate and align the camera assembly
yellow label with the skirt yellow label.
4. Secure the camera assembly to the skirt by
pushing it into the skirt, then twisting it
clockwise until it clicks securely in place.
5. Secure the camera assembly to the skirt by
twisting it clockwise until it clicks securely
in place.
6. Adjust the camera’s field of view (see Adjusting the Camera FOV (Field of View) on
page 25 ).
7. Install the turret by clicking it into place.
8. Install the bubble by placing it on the camera with the tabs to the left of the slots, then
turning it clockwise until the tabs click securely into place.
Skirt
Camera
assembly
Turret
Dome bubble
Screws
(supplied)