Washing sequence, Wash, How to change the direction of the drain hoses – haier AWT-120LI User Manual
Page 7
8
Washing sequence
8
4
3
2
1
5
SPIN TIMER
WASH SELECTOR
Install the water inlet hose; Select the water level
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Insert the water inlet hose into the water-filling
entrance on the control panel directly.(pull it
out to dismantle it)
Use the new water inlet hose provided
with the machine to connect to the
water faucet.Old hose sets should
not be reused.
5
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. T
ake off the drain hose from the cabinet.
T
ake the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the
side of the spin
tub
in the order
of (1)~(3), heading
for the
side of the spin
tub. (See to Figure
3).
Embed the drain hose into the groove with
hands. T
ake care not to damage the drain
hose in fastening the fixing clamp.
Figure 1
Extend the
drain hose from the
side of spin tub
Figure 3
Embed into the groove in turn
Extend to the spin tub side
Soft item
Back
Front
Figure 2
Soft item
Water inlet hos
e
Water inlet
Maximum
Max
Minimum
Min
Medium
Med
Water level
indicator
DRAIN SELECTOR
Spin timer
(T
o set to below 1 minute,
first
set to 2 minute
then
turn it back. it can increase the service life of the timer).
Was
h selector
(Standard current, strong current)
Drain selector
(Do
n
ot set drain selector
on Drain position during washing)
Wat
er inlet
W
ater filling
control handle
WA
S
H
SPIN
WASH TIMER
Wash timer
(T
o
set
to below 2 minute,
first set to
5
m
inute
then
turn it back. it can increase the
service
life
of the
timer).
OFFOFF
1212
9
6
3
1515
ST
ANDARD
ST
ANDARD
STRONGSTRONG
DRAINDRAIN
OF
F
OF
F
OF
F
OF
F
ST
ANDARD
ST
ANDARD
STRONGSTRONG
Wash
Figure 5
Figure 4
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the
laundries. (Figure 4)
6.After washing,the buzzer will ring .Set
the "DRAIN SELECTOR" at "DRAIN".
(Figure 5).
Figure 3
Figure 2
O
FF
OF
F
12
9
6
3
15
DRAINDRAIN
1
Inlet selector
(1) Set inlet selector to
Wash
side.
Figure 1
(2 )Adjust water level rod to a position as needed.
WASH
SPIN
Figure 1
O
FF
OFF