haier AWT-120LI - Manual (Page 6)

Midway spinning
Push
Push
Proper
Proper Outer cover of the spin tub
Inner cover of the spin tub
The laundries are slanting
Gland
No gland
1.
Put the laundries into the spin tub evenly and smoothly.
2.
Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. (2) Close the inner and outer cover of the spin tub. (3) Spin for 1-2 minutes.
9
3.
Run the foam-removing spinning.
1 2
Set
the inlet
s
elector
handle on spin side and
fill water
for
about
1 min.
Close the spin tub outer
cover
and spin
for
a
bout
1 - 2 min.
In case water
flows out
from wash tub side
due to too much inflow
,
p
lease turn down
the water
tap a bit.
Was
h
Spin
W
a
ter
inlet
Inlet
s
elector
handle
4
Installation
and
adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Usage of the drain hose
If the extra
hose is
too
long, cut it
either
at point
A
or B.
<10cm
B
A
> 30mm
<1.5m
The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage. 2.Do not tramp or press the drain hose. 3.If the drain hose is too long, cut it at mid point. T
o
make smooth drainage, cut the front end of
the hose slantingly. 4.If extra drain hose is needed , please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
Install the lint filter
After
installation,
please
refer
that
the
lint
filter
installed
to
the
right
s
tation,
otherwise
the
lint
filter
m
ay
be
fallen
off
when
washing,
influencing
your
use.
overflow
filter
lint fil
ter
Put the
underside of
the lint
filter into
overflow filter
then push
the upside
into overflow
filter.