Harbor Freight Tools 31810 - Manual (Page 8)

SKU 31810 For technical questions, please call 1-800-444-3353. Page 8
OPERaTINg INSTRUCTIONS
NOTE: For additional information regard-
ing the parts mentioned in the fol-
lowing pages, refer to the assembly
Diagram near the end of the man-
ual.
Turn the Power Switch off. Then,
1.
plug the Power Cord Plug into the
nearest 120 volt, grounded, electrical
outlet.
Connect the Dust Collector to a
2.
woodworking machine’s dust port us-
ing appropriate dust collection hoses
and clamps (sold separately), then
turn the Dust Collector on. After, turn
on the machine.
CaUTION: Only attach this dust collec-
tor to a woodworking machine.
When finished using the Dust Collec-
3.
tor turn it off. Unplug the Power Cord
Plug from its electrical outlet. Then
store the Dust Collector in a safe,
clean, dry location out of reach of
children and unauthorized users.
INSPECTION, MaINTENaNCE,
aND CLEaNINg
WaRNINg! Always make sure the Power
Switch is in its “OFF” position, and
unplug the Power Cord/Plug from its
120 volt electrical outlet before per-
forming any inspection, adjustments,
maintenance, or cleaning.
Before each use, inspect the general
1.
condition of the Tool. Check for loose
screws, misalignment or binding of
moving parts, cracked or broken
parts, damaged electrical wiring, and
any other condition that may affect
its safe operation. If abnormal noise
or vibration occurs, have the problem
corrected before further use.
Do not use damaged equipment.
Daily:
2. With a soft brush, cloth, or
vacuum, remove all dust and debris
from the exterior of the Tool.
CaUTION!
3. All maintenance, ser-
vice, or repairs not listed in this
manual are only to be attempted by a
qualified service technician.