Regulatory and safety, Led safety, Mercury safety – HP Digital VP6121 User Manual
Page 33: U.s.a
Regulatory and Safety 33
User’s Guide
REGULATORY AND SAFETY
This section presents information that shows how your digital projector complies with
regulations in certain regions. Any modifications to your digital projector not expressly
approved by Hewlett-Packard could void the authority to operate the digital projector
in these regions.
LED Safety
The infrared ports located on the digital projector are classified as Class 1 LED (light-
emitting diode) devices according to International Standard IEC 825-1 (En 60825-1).
This device is not considered harmful, but the following precautions are recommended:
•
If the unit requires service, contact an authorized HP service center.
•
Do not attempt to make any adjustment to the unit.
•
Avoid direct eye exposure to the infrared LED beam. Be aware that the beam is
invisible light and cannot be seen.
•
Do not attempt to view the infrared LED beam with any type of optical device.
Mercury Safety
Warning: This digital projector lamp contains a small amount of mercury. If the lamp
breaks, adequately ventilate the area where the breakage occurred. Disposal of this
lamp may be regulated due to environmental considerations. For disposal or recycling
information, please contact your local authorities or the Electronic Industries Alliance
(www.eiae.org)
U.S.A.
This digital projector has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This digital projector generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this digital projector does
cause harmful interference to radio or television reception (which can be determined
by unplugging the unit), try the following:
•
Reorienting or relocating the receiving antenna.
•
Relocating the digital projector with respect to the receiver.
•
Connecting the digital projector’s power cord to another power outlet.
Connections to Peripheral Devices. To maintain compliance with FCC Rules and
Regulations, use properly shielded cables with this device.
For more information, consult your dealer, an experienced radio/television technician,
or the following booklet, prepared by the Federal Communications Commission: How