Remove the server blade – HP PROLIANT SERVER BLADE BL460C G6 User Manual

Page 13

Operations 13

•

Use the Onboard Administrator GUI to initiate a shutdown:

Select the Enclosure Information tab, then select the Overall checkbox in the Device Bays item.

Initiate a shutdown from the Virtual Power menu:

—

Select Momentary Press to initiate a controlled shutdown of applications and the OS.

—

Select Press and Hold to initiate an emergency shutdown of applications and the OS.

IMPORTANT:

When the server blade are in standby mode, auxiliary power is still being

provided. To remove all power from the server blade, remove the server blade from the

enclosure.

After initiating a virtual power down command, be sure that the server blade go into standby mode by

observing that the system power LED is amber.

Remove the server blade

CAUTION:

Do not use the server blade release lever to lift or carry the server blade. Always

support the weight of the server blade by handling the chassis directly. Improper use can

damage the release lever and the server blade.

To remove the component:

Identify the proper server blade.

Power down the server blade (on page

Remove the server blade.

Place the server blade on a flat, level work surface.

WARNING:

To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION:

To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.