Hotpoint HDI90X - Manual (Page 12)

12 GB
CARE AND CLEANING
Before cleaning your cooker hood or carry out any
maintenance, switch off and remove the plug from
the socket to disconnect it from the electricity
supply.
CLEANING METAL GREASE FILTERS
The filters must be cleaned every 2 months of
operation, or more frequently with heavy usage,
and can be washed in a dishwasher.
• Remove the filters one at a time by pushing
them towards the back and pulling down at the
same time.
• Wash the filters, taking care not to bend them.
Allow them to dry before refitting.
• When refitting the filters, make sure that the
handle is visible on the outside.
REPLACING THE ACTIVATED CHARCOAL FILTER (RECIRCULATION VERSION)
The filter is not washable and must be replaced
after every 4 months of operation, or more
frequently with heavy usage.
• Remove the metal grease filters.
• Remove the saturated activated charcoal filter
by releasing the fixing hooks.
• Dispose of the charcoal filter.
• Fit the new filter by hooking it into its housing.
• Replace the metal grease filters.
LIGHT REPLACEMENT
20W halogen light
• Remove the 2 screws fixing the Lighting support,
and pull it out away from the hood.
• Extract the lamp from the support.
• Replace with another of the same type, making
sure that the two pins are properly inserted in
the lamp holder socket holes.
• Replace the support and fix it in place with the
teo screws previously removed (above).
CLEANING
• Clean with a sponge soaked in warm water and
a sodium bicarbonate solution, which is among
other things a good disinfectant. If you do not
have any, you can use a neutral soap.
• DO NOT use abrasive detergents, bleach or
detergents using ammonia.
• NEVER use solvent based products.
Failure to carry out the basic standards of cleaning and replacement of the filters could cause a fire
risk. Therefore you must observe these instructions.