HP N31.5 - Manual (Page 44)

44
Erasing a selection You also may erase a selection from a previously saved program. To erase a selec-
tion:
1. Load a CD for which you’ve already saved a program (the letter P
will appear preceding the track number on the display); or load an
unprogrammed CD, then assemble and save a program.
2. Using the next and previous (or track + and track – on the remote,
or the numbered buttons on the remote), select the track you want
to erase from your program.
3. Erase the selection to your program by pressing program – (on the
remote control, press prg/time , then press – ).
Note: You must press program – (or prg/time and – ) within five
seconds after making a selection, or the selection won’t be re-
corded.
4. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press program – (or prg/time and – ) after
each selection.
5. When you’ve finished adding selections, press program save ; the
display will show PROG CHANGED . This last step is what makes
your change permanent.
Temporarily overriding a
previously saved program
To override a previously saved program (temporarily), press program clear (on
the Remote Control, press the 0 numbered key, then press prg/time ); the display
will show PROG CLEARED .
All of the CD’s tracks will be accessible for basic operation, but the program will
still be retained in the Nº31.5’s memory. (See Basic Operation.)
Note: If you press program save after pressing program clear , the
display will show PROG DELETED and the program will be erased
from the Nº31.5’s memory.
Erasing a program To erase a previously saved program permanently from the Nº31.5’s memory:
1. Press program clear ; the display will show PROG CLEARED .
2. Press program save ; the display will show PROG DELETED .
Once again, this last step of pressing program save is what makes your change
permanent (as opposed to merely overriding the program this once).