HP N31.5 - Manual (Page 39)

39
Using indices If a CD has indices, you may use them to begin play in the middle of a track.
1. Press index mode . (If there was no CD in play, the display will
show INDEX SEARCH .) After a brief delay while the transport
searches the disc, the LED above the button will flash to indicate
index mode .
2. Using next and previous (or the numbered buttons on the Remote
Control), select an index.
3. Press play to begin play at the index you selected.
Beginning play at a
specific location in a track
You may use prg/time on the Remote Control to begin play at a specific time—
whether or not it corresponds to an index.
1. Using track + or track – , or the numbered buttons on the remote
control), select a track.
2. Press prg/time , then press the numbered buttons corresponding to
when you’d like play to begin. (The numbers you select will ap-
pear in the
time part of the display.)
3. To begin play at that point, press play .
Note: The time you select depends on the selection you’ve made
with the
display mode button: elapsed or remaining, CD or track.
For example, if you want to begin play one minute and thirty seconds into track
2, first press
display mode until the elapsed time and on track LEDs light. Then
select track 2 by pressing track + or track – (or by entering 02 ). Press prg/time ,
enter 130 , then press play .
The pause function To suspend play while a CD is playing, press pause . To resume play at the same
point, press pause again.
If left in pause for several minutes, the transport will stop spinning and the laser
will turn off (thereby enhancing the longevity of both). This will be indicated by
the
pause indicator in the display (“ || ”) flashing on and off. Alternatively, this
extended pause feature may be engaged by pressing and holding the pause
button until the indicator begins to flash in the display. Pressing pause again will
resume play at the point where pause was first pressed, (after a short delay to
allow the disc to get up to speed).
To “cue up” the beginning of a CD or track, press pause before pressing play (5).
To begin play, press pause again. (You may also select another track or index
while play is suspended.)
Repeating an entire CD To repeat (continuously) all tracks on a CD, press repeat disc . While the repeat
disc function is active, the LED above the button is lit. To return to normal play,
press repeat disc again.
Repeating a track To repeat (continuously) the track in play, press repeat track . While the repeat
track function is active, the LED above the button is lit. To return to normal play,
press
repeat track again.