Husqvarna 236E - Manual (Page 23)

English – 23
TECHNICAL DATA
1153140-26 Rev. 2 2010-02-11
Bar and chain combinations
The following cutting attachments are approved for the models Husqvarna 235e, 236e, 240e and 240e TrioBrake.
EC-declaration of conformity
(Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the chain
saws Husqvarna 235e, 236e, 240e and 240e TrioBrake from 2009’s serial numbers and onwards (the year is clearly
stated in plain text on the type plate with subsequent serial number), are in conformity with the requirements of the
COUNCIL’S DIRECTIVES:
- of May 17, 2006 "relating to machinery" 2006/42/EC
- of December 15, 2004 ”relating to electromagnetic compatibility” 2004/108/EC.
- of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
For information relating to noise emissions, see the chapter Technical data. The following standards have been applied:
EN ISO 12100-2:2003, CISPR 12:2001, EN ISO 11681-1:2004
Notified body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has carried out
EC type examination in accordance with the machinery directive’s (2006/42/EC) article 12, point 3b. The certificates for EC
type examination in accordance with annex IX, have the numbers: 0404/09/2047 - 235e, 236e, 240e 0404/09/2120 - 240e
Triobrake.
In addition, SMP, Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has certified conformity
with annex V of the Council’s Directive of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
The certificates have the numbers: 26/161/001 - 236e, 240e, 240e TrioBrake 26/161/002 - 235e.
The supplied chain saw conforms to the example that underwent EC type examination.
Huskvarna December 29, 2009
Ronnie E. Goldman, Director of Engineering, Handheld Consumer Products. (Authorized representative for Husqvarna AB
and responsible for technical documentation).
Bar Chain
Length, inch Pitch, inch Gauge, mm Max. nose radius Type
Length, drive
links (no.)
13 0,325
1,3
10T Husqvarna H30
56
15 0,325 64
16 0,325 66
18 0,325 72
14 3/8
7T Husqvarna H36
52
16 3/8 56