Harbor Freight Tools Central Machinery 10" Disc Sander-Bench Type 47404 - Manual (Page 2)

Page 2 SKU 47404 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS TABlE
Electrical Requirements 120 V / 60 Hz / 3/4 HP / 13.4 Amps
Single Phase / 1,750 RPM
Sanding Disc Diameter 10”
Sanding Disc Type Pressure Sensitive Adhesive (PSA)
Dust Collection Port 1-3/8” O.D.
Table Dimensions 11-3/8” W x 5-1/2” L
Table Tilt Angle 0 to 45 Degrees (Downward)
Table Tilt Scale Increments 15 Degrees
Miter Gauge Scale 0 to 60 Degrees
In 1 Degree Increments – Right and Left
Base Mounting Holes 3/8” (Qty: 2)
Base Dimensions 2 Base Legs at: 2” W x 8-7/8” L
SAVE THIS MANuAl
You will need this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures, parts list and assembly
diagram. Keep your invoice with this manual. Write the invoice number on the inside of the
front cover. Keep this manual and invoice in a safe and dry place for future reference.
gENERAl SAFETY WARNINgS AND PRECAuTIONS
1. KEEP WORK AREA ClEAN AND DRY. Cluttered, damp, or wet work areas
invite injuries.
2. KEEP CHIlDREN AWAY FROM WORK AREA. Do not allow children to handle
this product.
3. STORE IDlE EQuIPMENT. When not in use, tools and equipment should be
stored in a dry location to inhibit rust. Always lock up tools and equipment, and
keep out of reach of children.
4. DO NOT uSE THIS PRODuCT IF uNDER THE INFluENCE OF AlCOHOl OR
DRugS. Read warning labels on prescriptions to determine if your judgement or
reflexes are impaired while taking drugs. If there is any doubt, do not attempt to
use this product.
5. uSE EYE AND BREATHINg PROTECTION. Wear ANSI approved safety impact
eyeglasses and an ANSI approved dust mask when using this product. ANSI
approved safety impact eyeglasses and dust masks are available from Harbor
Freight Tools.
6. DRESS SAFElY. Do not wear loose clothing or jewelry, as they can become