Harbor Freight Tools Central Machinery 10" Disc Sander-Bench Type 47404 - Manual (Page 10)

Page 10 SKU 47404 For technical questions, please call 1-800-444-3353.
INSPECTION, MAINTENANCE, AND ClEANINg
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 12.
1. CAuTION: Always turn the Safety Switch (part #32) to its “OFF” position, unplug
the Power Cord/Plug (part #34) from its electrical outlet, and wait until the
Sanding Disc (part #14) has completely stopped spinning before performing any
inspection, maintenance, or cleaning.
2. BEFORE EACH uSE, inspect the general condition of the Disc Sander. Check
for loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other condition that may affect its safe
operation. If abnormal noise or vibration occurs, have the problem corrected
before further use. Do not use damaged equipment.
3. DAIlY: Sanding Discs (part #14) must be sharp and clean to perform properly.
Depending on materials sanded and frequency of machine use, Sanding Discs
become clogged with wood, metal particles, and become dull. Dull Sanding
Discs rub the workpiece rather than cut, which results in increased friction, higher
temperatures, and a burned workpiece. As often as possible, check the condition
of the Sanding Disc and, if necessary, replace a worn Sanding Disc with a new,
10” Pressure Sensitive Adhesive disc. (See “To Attach A Sanding Disc To The
Disc Sander” section in this manual for further information.)
4. DAIlY: With a soft brush, cloth, or vacuum, remove all debris from the Disc
Sander. Then, use a premium quality, lightweight machine oil to lubricate all
moving parts.
PlEASE READ THE FOllOWINg CAREFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.