Harbor Freight Tools 95578 - Manual (Page 12)

SKU 95578 For technical questions, please call 1-800-444-3353. Page 12
SPECIFICATIONS
Electrical Input 120 V~ / 60 Hz / 4.3 A
Motor No Load Speed 11,000 RPM
Max. Accessory
Diameter
4-1/2” (114 mm)
Arbor Hole Diameter 7/8”
Spindle Thread 5/8” x 11 TPI
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool off and unplug the tool
from its electrical outlet
before assembling or making
any adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Adjusting the Wheel Guard
TO PREVENT
SERIOUS INJURY:
Do not operate this tool
without the Wheel Guard
properly installed.
1. Loosen the Wheel Guard Bolt.
2. Rotate the Wheel Guard as needed
to shield you during the planned
work.
3. Tighten the Wheel Guard Bolt
securely.
4. Check the Wheel Guard to ensure it
is firmly in place. Adjust if necessary
before proceeding.
Installing the Side Handle
TO PREVENT
SERIOUS INJURY:
Do not operate this tool with
one hand only or without the
Side Handle properly
installed.
5. The Side Handle may be installed on
either side of the Gear Housing.
6. Screw the threaded end of the Side
Handle into the selected position.
Tighten securely before beginning
work.
REV 10d