Harbor Freight Tools CENTRALPNEUMATIC 97526 - Manual (Page 5)

Page 5 SKU 97526 For technical questions, please call 1-800-444-3353.
UNPACKING AND SET UP
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
NOTE: READ ALL INSTRUCTIONS
BEFORE USING THIS PRODUCT
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram on
page 9 of this manual.
WARNING! Make sure the tool is
unplugged from its air supply before
making any adjustments to the tool.
Also make sure the Magazines (47
and 51) are empty before set up or
maintenance.
Quick
Coupler
Recommended Air Line Components
Regulator with
Pressure Gauge
Quick
Coupler
Air Hose
on Reel
Valve Filter Oiler
Coupler
Plug
Tool
Air
Compressor
Coupler
Plug
NOTE: For best service, you should
incorporate an oiler, regulator, and
in-line filter as shown above. Hoses,
couplers, oilers, regulators and filters
are all available at Harbor Freight
Tools.
If you are not using an automatic
oiler system, before operation add a
few drops of Pneumatic Tool Oil (not
included) to the airline connection.
Add a few drops after each hour of
continual use.
Set the air pressure range on the
regulator so that it is between 60 and
100 PSI. Do not exceed 100 PSI.
LOADING THE NAILER
1. Depress upper tip of the Click Lever
(59). The Side Cover (34) will pop
open.
2. Insert a row of fasteners (not
included) into the Upper Right
Magazine (47/51). Make sure the
pointed ends of the fasteners are
loaded with the points downward.
Also make sure fasteners are not
dirty or damaged.
3. Slide the Side Cover (34) back over
the Upper Magazine (47/51) and
press the upper tip of the Click Lever
(59) in ward to lock Side Cover (34)
in place.