Cleaning tools, Edge cleaning, Select proper tool – Hoover Bagless Upright Vacuum Cleaner User Manual
Page 7: Stair cleaning, Remove hose
7
Edge cleaning
Edge cleaning is provided on both sides
of the nozzle to remove dirt in carpet
near baseboards and furniture.
Guide either side of nozzle parallel to
edge of carpet or furniture.
Cleaning tools
Tools allow for cleaning surfaces above
the floor and for reaching hard to clean
areas.
The cleaner is ready for tool use when
handle is in upright position.
CAUTION: Agitator continues to
rotate while cleaner handle is in
upright position. Avoid tipping clean-
er or setting it on furniture, fringed
area rugs or carpeted stairs during
tool use.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
2-10
2-11
2-13
C
A
B
D
E
G
F
Select proper tool
C. Dusting brush
may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
D. Furniture nozzle
may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
E. Crevice tool
may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
F. Crevice wand
(stores inside exten-
sion wand) can be used in tight spaces,
corners and along edges in such places
as dresser drawers, upholstered furni-
ture, stairs and baseboards. It can also
be used for extra reach with the dusting
brush and/or extension wand.
G. Extension wands
are used to give
extra length to your hose. Use it with any
of the above tools.
2-12
Stair cleaning
A stair cleaning handle has been
designed for ease in using your cleaner
on stairs. With handle in operating posi-
tion, place fingers under edge of stair
cleaning handle and guide cleaner with
other hand on upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the agita-
tor will continue to rotate.
CAUTION: To avoid personal injury or
unnecessary wear to carpet, and to
prevent the cleaner from falling,
always place it at the bottom of the
stairs.
Remove hose
When using cleaning tools,
cleaner
handle should be in the upright posi-
tion.
Also,
turn cleaner OFF before
disconnecting and connecting hose
to hose tube (A).
To use hose, lift hose end as shown.
Lower cover (B) onto hose tube. When
you are finished cleaning with the tools,
be sure to lift cover from hose tube
and reposition hose end into tube.