Hoover Bagless Upright Vacuum Cleaner - Manual (Page 6)

Handle position
For ease in sliding knob, place handle
in the upright position (C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
• Lowest setting: for all types of carpet
and hard floors.
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) as shown and will prevent
rug from clinging to cleaner. Continue to
lift up nozzle so that when you have
reached the edge, it is completely off
the rug. Move cleaner back to start
again, lower nozzle, and use only for-
ward strokes.
6
Carpet height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (A).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, slide
the nozzle control knob (B) to the desired
setting.
2-9
Carrying handle
Use the carrying handle to lift the
cleaner.
Transporting cleaner
Put handle in upright position. Tilt
cleaner back on rear wheels. Push
forward.
2-4 2-5 2-6
2-7 2-8
B
D
Hard
Floor High
C
A