The tanks – Hoover 800 User Manual

Page 9

Pour cleaning concentrate into tank (B). Fill tank to

fill line (C) (1 quart) with warm water.

DO NOT use cleaning concentrates that contain solvent based ingredients.

CAUTION: HOOVER® Floor to Floor™ Cleaning Concentrate and HOOVER® Grout Cleaner

cannot be used in Hoover SteamVac™ products. Doing so could damage your SteamVac™ Cleaner.

Turn cap (A) upside down to serve as a measuring cup.

For hard surface floors such as vinyl, linoleum, laminate

wood, polyurethane sealed wood or other wood floors that can
normally be cleaned using water

, use one cap (2 oz.) HOOVER®

Floor to Floor™ Cleaner.

Check for worn spots or joint separations before using, as these
conditions could lead to damaged flooring when using water to
clean floor.

When cleaning ceramic and other tiles

, use the set of grout

brushes with gray bristles included with your FloorMate™

SpinScrub™ 800 Cleaner. Use these for tile floors where extra

attention is needed for cleaning grout. (See “Cleaning the brush-

es” section for how to remove and replace the brush assemblies.)

Using cap (A), measure 1-1/2 capfuls (3 oz.) of HOOVER® Grout

Cleaner.

To remove tank, squeeze release button and pull tank

straight out.

Carry tank to a sink.

Rotate tank cap counter-clockwise and lift up to remove cap

(A).

Solution (upper) tank

The solution tank holds detergent and water that is to be

dispersed onto the surface being cleaned.

How to fill

Disconnect cleaner from electrical outlet.

Place cleaner handle in upright, locked position.

The tanks

Continued ➜