Storing the cleaner – Hoover 800 User Manual

Page 15

Before storing cleaner:

Turn cleaner OFF and disconnect from electrical outlet.

• Empty and rinse solution and recovery tanks. Allow to air

dry.

• Press on upper handle release button to lower handle for

storage.

• Make sure that nothing is pressing on the nozzle squeegee.

• Do not store cleaner on a wood surface unless cleaner is

completely

dry.

For your convenience, the HOOVER® FloorMate™

SpinScrub™ 800 tool caddy (A) is provided for storing

the hose, tools, telescoping wand, set of brushes and

detergent.

The two sections of the tool caddy snap together for assembly.

Press where indicated by arrows to snap securely in place. The

caddy conveniently fits over the top of the cleaner nozzle (B)

for storage.

To store hose:

Place the hose grip (C) into slot (D) on

back of caddy. Pull hose up and press into cut-out area

(E). Continue wrapping hose down, underneath tongue (F),

and back up, pressing into second cut-out area (G). Place hose

end (H) into slot (I) on back of caddy.

Place floor swivel tool (J), grout tool (K), brush assembly

(L), telescoping wand (M) and detergent (N) into caddy

as shown.

Using the tool

Storing the cleaner

Tool caddy

The handle must be in the upright position in order

to get cleaning solution through the hose.

✓ Squeeze and hold trigger (A) in hose grip to release

cleaning solution.

✓ Let go of trigger and pull tool over same area to pick

up dirty solution without putting down more solution.

NOTE:

It may be necessary to remove air from the system

(prime the pump) so the clean solution will flow to the tool.

After attaching the tool to the hose, turn the cleaner ON. Put the

tool against your hand to block off the suction. Wait a few sec-

onds, then squeeze the trigger and begin cleaning.

Continued ➜