Harley-Davidson B3160 - Manual (Page 20)

20
Assembly
.354 (Small Diameter)
Cap Nut
Fork Axle
• Place a .354 (small diameter) cap nut on a flat surface,
inside up. Fit the end of the fork axle into the cap nut.
• Tap the opposite end of the fork axle with a hammer to
secure the cap nut on the axle. Pull on the cap nut to
make sure it is securely assembled.
.354"
.354 Cap Nut
39
TM
Steering
Stop
Neck of
Vehicle Body
• First, fit the tab on the steering stop into the curved slot
in the lower steering bushing .
• Hold the steering stop in place.
• Then, slide the handlebar assembly on the vehicle frame
neck and over the steering stop
.
Handlebar
Assembly
38
TM
Tab
Handlebar
Harness
• Fit the handlebar harness behind
the tab in the vehicle frame neck.
See
Inset
Tab
Handlebar
Harness
36
TM
• Fit the remaining steering bushing onto the top of the
vehicle frame neck.
• Insert two #8 x 3 /
4
" screws into each end of the steering
bushing and tighten.
Steering
Bushing
37