Harley-Davidson B3160 - Manual (Page 17)

17
Assembly
Wire
Cover
Switch Switch
Peg
Switch
Cover
• Fit the wrapped portion of the handlebar harness into
the wire cover.
• Fit the tab on the wire cover into the notch in the switch
to lock the two parts together.
Handlebar
Harness
25
Right
Handlebar
• Locate the right handlebar. The right handlebar has an
additional hole in the grip area.
• Fit the switch to the right handlebar, making sure the
screw hole in the switch aligns with the screw hole in
the right handlebar.
Switch
Cover
26
• Fit the switch cover peg through the hole in the right
handlebar and the switch.
• While holding the two parts firmly together, insert
two #8 x 3 /
4
" screws into the switch and tighten.
27
• Fit a handgrip on the end of each handlebar.
Hint: If it is difficult to slide the handgrips onto the handle-
bars, moisten the inside of the handgrips with water.
Handgrip
Handgrip
Handlebars
28
Wire
Cover
Tab Switch
Notch
Additional Hole
in Grip Area
Right Handlebar