HONDA MM60 - Manual (Page 52)

MAINTENANCE
Drive Pulley Installation
1. Install drive pulley with split taper bushing on
gearbox vertical shaft. Make sure key and
keyways are aligned.
3
2. Position centerline
of driie pulley 0.98 & 0.030 in.
above mounting surface
of gearbox stand as
shown. This is a very criiical dimension and
must be held. Alternately tighten split taper
bushing set screws to 2 kg/m
(14 ft/bs). Check
mounting distance to make sure it is correct.
1. Split taper bushing
2. Drive pulley
3.
Gearbox stand
4. Key
Drive Pulley Assembly
51