HONDA MM60 - Manual (Page 36)

INSTALLING MOWER
Using Rear Three Point Hitch with Mower
Detached While the Mower Lift Linkage is
Still Installed
1
. Detach mower as described below.
2. Start engine and set Lift Control Lever on "UP"
to raise lift arms to maximum position. Turn
off
engine, turn Lowering Speed Control fully
clockwise to lock hydraulic system and set
brakes.
NOTE: Block the
lift plate to its full UP position.
3. Pull pin from projecting bracket at top of left
hand lift rod, and remove as illustrated to
release
lift chain. Hold chain
so that it does not
fall.
4. Attach lift chain to projecting chain rest pin on
the Roll Over Protection System. Secure with
washer and cotter pin. MAKE SURE TO RE-
TAIN CLEVIS PIN IN SAFE PLACE TO BE ABLE
TO RE-ATTACH CHAIN TO
LIFT ROD.
5. Install attachment as needed.
35