Harbor Freight Tools 94855 - Manual (Page 6)

Charger by pulling on the Power Cord. Keep the Power Cord away from heated
surfaces.
8. To avoid electrical shock, do not handle the Charger (48), its Power Cord Plug,
or the Impact Wrench with wet hands.
9. Keep the Handle of the Impact Wrench dry, clean, free from oil and grease.
10. Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Impact Wrench.
11. Never leave the Charger (48) unattended when it is plugged into an electrical
outlet. Make sure to unplug it from its electrical outlet before leaving.
12. Always turn off the Impact Wrench and unplug the Charger (48) from its
electrical outlet before changing accessories or performing any inspection,
maintenance, or cleaning procedures.
13. Always switch to a fresh Battery (30) when tool performance begins to
diminish. Severe heat is most destructive to a Battery. The more heat generated,
the faster the Battery loses power. A Battery that gets too hot can be permanently
damaged. Never over-discharge a Battery by using the tool even after tool
performance is decreasing. Never attempt to discharge a tool’s Battery by continuing
to pull the tool’s trigger. When tool performance begins to diminish stop the tool,
recharge the Battery, and use the fresh Battery for optimal performance.
14. Battery (30) leakage may occur under extreme usage or temperature
conditions. If Battery fluid comes in contact with skin, wash with soap and water
and rinse with lemon juice and vinegar. If the fluid comes into contact with the eyes,
flush with water for several minutes and contact a doctor immediately.
15. Never burn the Battery, as it can explode in a fire. Do not charge the Impact
Wrench if it has a leaking Battery. Contact local solid waste authorities for instructions
on correct disposal or recycling of the Battery.
SKU 94855 PAGE 6
WARNING: This product contains or, when used, produces a chemical known to
the State of California to cause cancer and birth defects or other
reproductive harm. (California Health & Safety Code 25249.5, et seq.)
16. WARNING! People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.