Harbor Freight Tools 94855 - Manual (Page 12)

1. Before installing the Socket (49), make sure the Battery (30) is removed from the
Impact Wrench to avoid accidental starting. Then, firmly insert and lock in
place the Socket onto the 1/2” Impact Head of the tool.
2. Whenever possible, secure the work piece in place, using a vise or clamps (not
included).
3. Insert the fully charged Battery (30) into the Handle of the Impact Wrench, and
rotate the Battery 180 degrees to lock the Battery in place.
4. Use the Forward/Reverse Button to select the turning rotation of the Impact
Wrench.
5. Insert the Socket (49) onto the nut that is to be loosened/tightened. NOTE: If
using the accessory 1/2” Socket, the nut itself must be 1/2”.
6. Make sure to hold the Impact Wrench firmly with both hands, as torque from the
Motor will cause the tool to twist. Then, squeeze the Trigger Switch (21) to turn
on the Impact Wrench. The more you depress the Trigger Switch (21) the faster
the Impact Wrench will turn.
SKU 94855 PAGE 12
BATTERY (30)
CHARGER BASE (50)
RED CHARGING
INDICATOR
LIGHT
PLUG INTO
120 VOLT, GROUNDED,
ELECTRICAL OUTLET
FIGURE 1
7. When finished, release the Trigger Switch (21) to stop the Impact Wrench. Then,
remove the Battery (30) and Socket (49) from the tool.
GREEN POWER
INDICATOR
LIGHT Tabs
FIGURE 2
NOTE: To connect the Charger Base (50)
to the Battery (30), press in the tabs on
the Battery while you slide the Charger
Base forward.
Tabs
CHARGER BASE (50)
Tabs
OPERATING INSTRUCTIONS