HONDA 2009 Civic Coupe - Manual (Page 106)

If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window fuse is removed, the
AUTO function could be disabled. If
the power window system needs to
be reset after reconnecting the
battery or installing the fuse, do this:
Start the engine. Push down and
hold the driver’s window switch
until the window is fully open.
Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
for about 2 seconds.
If the power windows do not operate
properly after resetting, have your
vehicle checked by your dealer.
When you push the MAIN switch in,
the switch is OFF, and the
passenger’s window cannot be raised
or lowered. To cancel this feature,
push on the switch again to get it to
pop out. Keep the MAIN switch off
when you have children in the
vehicle so they do not injure
themselves by operating the window
unintentionally. If the driver’s
window runs into any obstacle while
it is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
Only on the driver’s window,
the auto reverse function is disabled
when you continuously pull up the
switch.
The windows operate for up to 10
minutes after you turn off the
ignition switch. Opening either door
cancels this function.
1.
2.
Except DX and Canadian DX-G All models
Power Windows
AUTO REVERSE
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
103
NOTE:
2009 Civic Coupe
Table Of Contents Main Menu