haier L32A9 - Manual (Page 10)

8
Descriptions of remote control function
Using remote control
Note:Pressing most buttons once will activate the assigned function. Pressing a second time will de-activate it.
When a button enables multiple options, a small list will be shown. Press repeatedly to select the next item
in the list. The list will be removed automatically after three seconds or press OK to remove immediately.
POWER
Press to turn the LCD TV On or off
VIDEO/S-VIDEO BUTTON
Press the button to select CVBS-1,
CVBS-2 and S-VIDEO
HDMI/COMP BUTTON
Press to select YPbPr, HDMI 1, HDMI 2
PC
Press the button to select PC source
TV BUTTON
Press the button to select TV source
NUMBER BUTTON
Press the number buttons for direct
access to the TV channels. For 2 digit
channel, enter the 2nd digit after enter
1st digit
PRE CH
It is only used in TV mode to go back to
the previously watched TV channel.
SLEEP BUTTON
Press to set the LCD TV to turn itself off
within a certain time
SOUND BUTTON
Press this button, you can choose 3
smart mode: personal, speech, music.
When in personal mode, you can
choose Bass, Treble.
NICAM
Press repeatedly to select Mono,
Stereo. Note: The sound mode
selections depend on TV program and
broadcast TV channel of that region.
FREEZE BUTTON
It is used to freeze an instant picture,
and you can return to normal watching
by pressing any key.(Note: It only works
in TV mode. Do not use freezed picture
for long so as not to burn the screen.
WIDE BUTTON
Press this button to display a list of
available display formats. Available
display formats are determined by
the type of signal you are receiving.
To choose the display format you
prefer, press the WIDE button
repeatedly: 4:3, ZOOM 1, ZOOM 2,
1:1(For 720P/1080I).
MUTE BUTTON
Press to eliminate or restore the
LCD TV sound. Mute will appear on
the screen when the sound is muted
DISPLAY BUTTON
Press to see the current channel
information on the TV screen
VOL+/-
Press + or - to adjust the volume
CH +/-
Press to adjust the channel up or
down
MENU
Press menu to activate on screen
menu on/off
SOURCE BUTTON
Press to select the video input
source: TV, CVBS-1, CVBS-2,
S-VIDEO, YPbPr, HDMI1, HDMI2,
VGA.
OK BUTTON
Press the button to conf rm your
selection
EXIT BUTTON
Press the button to exit OSD menu
PICTURE BUTTON
Press this button, you can choose
standard, vivid, movie, personal,
enco.