beautypg.com

Troubleshooting, Trouble shooting chart – Husqvarna 521SSR User Manual

Page 27

background image

TROUBLE SHOOTING CHART

27

1740274

PROBLEM

LOOK FOR

REMEDY

Difficult starting

Defective spark plug.

Replace defective spark plug.

Engine runs erratically Blocked fuel line.

Clean fuel line.

Empty gas tank.

Check fuel supply,

Stale gasoline.

Add fresh gasoline.

Water or dirt in fuel system.

Remove carburetor bowl to drain fuel tank. Refill
with fresh fuel.

CAUTION: Do not remove

carburetor bowl when the engine is hot.

Engine stalls

Unit running on CHOKE.

Set choke lever to RUN position.

Loss of power

Gas cap vent hole is plugged.

Remove ice and snow from cap. Be sure vent
hole is clear.

Excessive vibration

Loose parts.

Stop engine immediately and remove spark plug
wire. Tighten all bolts and make all necessary
repairs. If vibration continues, have the unit
serviced by a competent repairman.

Unit fails to propel
itself

Drive belt loose or damaged.

Replace drive belt. Refer to Drive Belt
Replacement
in the Maintenance section of this
manual.

Incorrect adjustment of traction drive

cable.

Adjust traction drive cable. Refer to Cable
Adjustment
in the Maintenance section of this
manual.

Unit fails to discharge

snow

Auger drive belt loose or damaged.

Replace or adjust auger drive belt. Refer to Drive
Belt Replacement
and Drive Belt Adjustment in
the Maintenance section of this manual.

Auger control cable not adjusted

correctly.

Adjust auger control cable. Refer to Cable
Adjustment
in the Maintenance section of this
manual.

Discharge chute clogged.

Stop engine immediately and disconnect spark
plug wire. Refer to the first Warning in
Snowthrower Operation in the Operation
section of this manual. Clean discharge chute
and inside of auger housing.

Foreign object lodged in auger.

Stop engine immediately and disconnect spark
plug wire. Remove object from auger housing.

Identifying Your Snowthrower

Your new snowthrower has two (2) identifying numbers: (1) unit model number: (2) unit serial number. The two preceding

numbers are required to insure that the proper replacement parts are obtained when required. If you have any questions

concerning parts, service, or technical data, contact your nearest Authorized dealer.

For complete warranty information refer to the warranty in the Owner’s Information section of this manual.

This manual is related to the following products: