Service recommendations – Husqvarna 521SSR User Manual
Page 19
SERVICE RECOMMENDATIONS
19
1740274
HOW TO LUBRICATE THE IDLER ARM
CAUTION: DO NOT get oil on the belt or pulleys. This will
cause the belt to slip and experience premature failure.
1. Remove the screws from the belt cover (see Figure 12).
Remove the belt cover.
2. Apply a drop of oil to the idler arm at point B (see
Figure 13).
3. Pivot the auger bail up and down several times.
4. Wipe off the excess oil.
5. Install the cover.
Belt Cover
Figure 12
Figure 13
B
Idler Arm
This manual is related to the following products:
See also other documents in the category Husqvarna Special machinery:
- 96193005500 (44 pages)
- 1130SBE (32 pages)
- 8024ST (32 pages)
- ST 268EP (68 pages)
- 96193004400 (40 pages)
- 16530 EXL (24 pages)
- EU1130STE (60 pages)
- 924SB-XLS (40 pages)
- 5524ST (60 pages)
- 96193006300 (20 pages)
- 96193005400 (24 pages)
- 10530SBE (32 pages)
- 8527SBEB (32 pages)
- 1130STE XP (32 pages)
- HUV 4414 (57 pages)
- 1130SB-XLS (40 pages)
- ST724 (40 pages)
- 927SBEXP (32 pages)
- HUV 4421 4421-D/DX/DXL (68 pages)
- 96193005700 (24 pages)
- 1330SB-XLSB (40 pages)
- 1027STE (32 pages)
- 96193005200 (24 pages)
- Z1-9 Collection System 968999196 (24 pages)
- 5524SEB (32 pages)
- HUV 4213-G (52 pages)
- 1330SBEXP (32 pages)
- 1130SB-LS (44 pages)
- 1830SB (24 pages)
- 1827EXLT (28 pages)
- HUV 5420 DXR (56 pages)
- HUV4421DXP (60 pages)
- 96193006400 (24 pages)
- 10530SBEB (32 pages)
- 10527SBE (32 pages)
- 8527 STE (32 pages)
- 1130ST (32 pages)
- HUV 4421-D / DXP (64 pages)
- 524S (32 pages)
- 1827SB (20 pages)
- 4210-G (56 pages)
- 5021 E (42 pages)
- 8527SBE (32 pages)
- 96193005301 (24 pages)