Harmar Mobility HIGHLANDER CPL1200 - Manual (Page 12)

Manual Override
Your lift is equipped with a manual
handcrank, to be used in the case of a power
failure.
Step 1
Before using the manual handcrank verify
that it’s use is required. Check that the
emergency stop switch is pulled out. Check
that the electrical cord is connected to the
supply. Also check that the buildings circuit
breaker has not tripped. Try to run the lift by
pushing both the up and down buttons. If the
lift still will not run, complete the following
steps:
Step 2
Disconnect the power from the lift.
Warning: Do not service or operate the
manual handcrank while the lift is
connected to electricity.
Step 3
Remove the screws and remove the top cap
at the top of the tower.
Step 4
Insert the manual handcrank into the
opening on the top of the brake assembly. It
may be neccesary to slightly rotate the
handcrank until it fully seats down on the hex
portion of the brake. Rotate the crank to
raise or lower the platform.
Warning: Never operate the lift while the
manual override crank is inserted into the
lift.
Call-Sends (optional)
The optional Call-Send controls are to be
used at the upper and/or lower landings to
call the platform to you or send it to the other
landing.
They should be mounted on the wall at each
landing at a convenient height. Consult local
codes for placement with consideration to
clearances.
12
A length of multi‐conductor wire will
need to be ran from the bottom of the lift
tower up to the landing Call‐Sends.
Consult local codes for type and
mounting requirements. After wiring is
completed, the wiring harness must be
plugged into it appropriate receptacle on
the controller (ref pg 5).
Wiring Connections
Call‐Send
Lift Harness
Blue Blue
White White
Red Red