Heath Zenith Wireless Dual Push Button Accessory SL-6200 - Manual (Page 6)

-6- 598-1144-02
Troubleshooting
Chime does not sound:
• Make sure push button and chime codes are the same (See
pages , 4, and 5).
• Check orientation of push button battery (See page 5).
• Check charge of push button and chime batteries (if ap-
plicable), replace if necessary.
Batteries seem OK, but the chime does not work when
installed:
• Do not mount chime or push button on metal or near metal
studs. This reduces the transmitter range. Use 1/4" to 1/2"
(6 to 1 mm) wood shims to move chime or push button off
metal surface.
• Concrete floors may reduce range. Move chime away from
floor.
• Try locating chime closer to push button.
The range of the wireless chime can vary with location, tem-
perature and battery condition.
Label Push Buttons
Using a small flat head screw-
driver or fingernail, carefully pry
off the label covers on the front
of the push button. Remove and
write relevant information on
labels. Replace label covers.
Label
Covers
Labels