Assembly – Husqvarna 968999515 User Manual

Page 8

CONTAINER ASSEMBLY
(See Figure 3)

1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lift top

half to meet bottom half.

3. Press halves tightly together while lifting top

to lock into place as shown.

IMPORTANT: BEFORE LOCKING THE TABS,

HOOKED EDGES ON BOTH HALVES MUST

OVERLAP TO FORM SEAL AS SHOWN IN IN-

SET.

FIGURE 3

ASSEMBLY

ASSEMBLY CHECK: Squeeze sides of lower half

of container and check that there is no gap be-

tween upper and lower halves. If a gap appears,

unlock tabs to separate container halves and re-

peat instructions above.

CONTAINER MOUNTING
(See Figure 4)

1. Install one container to left side first with

warning to the outside of unit. Install another
container to center position and one in right
position.

NOTE: Right container should always overlap left
container at center supports.

2. Close cover and lock latch handles over

center support tubes.

FIGURE 4

WARNING

DO NOT

operate mower unless container

is properly installed. Container is subject
to wear and deterioration, check contain-
ers frequently, replace when cracked or
damaged. Use only a recommended re-
placement container.

CONTAINER
BOTTOM
HALF

CONTAINER
TOP HALF

CONTAINER
BOTTOM
HALF

PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF

LOCKING
TAB

COVER LATCH
HANDLES

CONTAINER
WARNING

CENTER
SUPPORT
TUBES

CONTAINER
HANDLE

CONTAINER
WARNING

4. Repeat for other containers.