HP LTO 4 SAS - Manual (Page 15)

HP LTO Ultrium 4 drives technical reference manual, volume 5: UNIX, Linux and OpenVMS configuration guide 13
Figure 2 SAM text-based interface
For HP-UX 11i v1 (11.11)
1. Enter sam at the command line.
% sam
2. Select the following:
Kernel Configur ation
Driv ers
3. Highlight the stape driver. If the driver has not been added to the kernel, both Current State
and Pending State will read “Out”.
4. Select the following:
Actions
Add Driver t o Kernel
The Pending State will now read “In”.
5. To add the new driver to the kernel, select:
Actions
Crea te a New Kernel
The stape driver is added to the kernel.
6. If you are going to attach an autoloader, use a similar procedure to change
schgr
to “static”.
7. Reboot the system.
For HP-UX 11i v2 (11.23)
1. Enter sam at the command line.
% sam
2. Select the following:
Kernel Configuration
Kernel Configuration (character mode)
Modules