Hotpoint HDA2600K User Manual

Page 9

DISPLAY

WHAT IT

WHAT TO DO

BLOCKED

Similar to blocked drain as

Locate and remove the blockage in the drain system as

DRAIN

explained on page 8, but the

explained on page 8. To pump any remaining water out of

and

indicates that the drain is so

the machine:

clogged that the dishwasher

1. Latch door.

cannot continue to operate in a
satisfactory manner. Dishwasher

2. Select any cycle.

will stop.

3. Touch “START” and then immediately touch “CLEAR/

RESET.”

Warranty service does not cover

household drain problems.)

Dishwasher will not go into

Restart the cycle. If

repeats, call for service.

a drain out period. Dishwasher
will stop.

There is too much water in the

The dishwasher is designed to automatically pump out extra

dishwasher. If

appears after a

water as long as the door is latched. When you hear the

power failure, this is normal and

motor stop running:

the dishwasher will correct itself.

1. Unlatch the door and see

the water is gone. (It is

normal for a small amount of water to remain in the
bottom of tub to keep the water seal lubricated. )

2. If you see water entering the dishwasher, close and latch

the door. Shut off the water supply to the dishwasher.

3. If water is gone and no water is entering the dishwasher,

restart cycle.

repeats, shut off the water supply to the dishwasher.

Call for service.

This can be caused by either of

these reasons:

Not enough water is entering the

Unlatch the door. If there is no water in the bottom of the

dishwasher.

dishwasher, check the water supply to the dishwasher.

●

Is the dishwasher water supply turned on?

(Valve usually located under the sink.)

●

Is the household water supply turned on?

●

If you use well or cistern water, is the supply adequate?

If the water supply is adequate, try the cycle again. If
repeats, call for service.

The drain pump could be

Unlatch the door. If there is standing water in the bottom

temporarily blocked (usually

of the dishwasher,

the door. Touch

then

caused by food particles such

immediately touch “CLEAR/RESET” to start the pump.

as cereal).

continues to appear, you may need to do this several

times to break up the blockage.

(continued

next page)