Humminbird 778C - Manual (Page 57)

49
Side
(WideSide® transducer: WideSide® View only)
Settings: Left, Both, Right; Default = Both
Side sets which transducer beam from the WideSide® Transducer will be
shown in the WideSide® View.
The Side menu option is available when a WideSide® transducer is connected
to the Fishing System and Transducer Select is set to WideSide® (see Sonar
Menu Tab: Transducer Select). This option can only be accessed from the
Sonar X-Press™ menu in the WideSide® view.
NOTE: The Side setting requires the purchase of the WideSide® transducer. Visit
our Web site at humminbird.com to order this accessory online or contact our
Customer Resource Center at 1-800-633-1468.
Sensitivity
Settings: Low = 1, High = 20; Default = 10
Sensitivity controls how much detail is shown on the display and will adjust
the sensitivity of all sonar frequencies.
When operating in very clear water or greater depths, increase the sensitivity
to see weaker returns that may be of interest. If the sensitivity is adjusted too
high, the display may become too cluttered.
Decrease the sensitivity to eliminate the clutter from the display that is
sometimes present in murky or muddy water. If Sensitivity is adjusted too low,
the display may not show many sonar returns that could be fish.
NOTE: The Sensitivity setting is a global setting and will adjust the sensitivity
of all sonar frequencies.
Sensitivity at High
Sensitivity at Medium Sensitivity at Low
Sonar X-Press™ Menu