Hobie HCE 2010 - Manual (Page 34)

Ref : MA_WILDCAT_FR Issued by : Alban ROSSOLLIN Date : mars 2010 Up-date : 3 Page 34/49
ASSEMBLY MANUAL : HOBIE WILD CAT
Copyright HCE 2010
2. Installation of the spinnaker trumpet
Position the spinnaker trumpet on the boom taking into
consideration two parameters :
- Once the sock is taut it should be at about 10 cm behind the
front crossbar,
- The mouth should be perpendicular to the pulley at the end of
the boom.
Drill the boom with a 8 mm bit through the holes of the trumpet;
screw to the boom with the screws that are supplied.
The sock should be taut with the least folds possible.
Take the holding rope of the trumpet and make a loop around the
spinnaker boom, hold in place with a bowline knot, then tighten
the end through the opening of the trumpet and bring to be
attached to the bridle support on the hull.
…/…
Spinnaker kit assembly Spinnaker kit assembly