Hobie HCE 2010 - Manual (Page 18)

Ref : MA_WILDCAT_FR Issued by : Alban ROSSOLLIN Date : mars 2010 Up-date : 3 Page 18/49
ASSEMBLY MANUAL : HOBIE WILD CAT
Copyright HCE 2010
1. Place the hulls parallel to each other with the insides face down on the
ground. Take the right hull and turn it right side up, one person should
stand astride it to hold it in place.
2. Take the font crossbar (the one that has the martingale and the
trampoline pre-assembled). Turn it so that it enters into its socket,
being careful to have the trampoline towards the back.
3. Insert the two bolts and washers in the order shown in the photo.
Tighten gently without forcing. Now take the left hull, and proceed in
the same way as for the right hull. Do not tighten completely
4. Position the back crossbar on the right-hand side. Insert the bolts and
washers as for the front crossbar. Repeat the same action on the left-
hand side.
5. Once that the frame is assembled, tighten the whole assembly.
It is recommended to check the tightness of all screws, bolts and
the forestay of the martingale after the first navigation, and then at regular intervals.
Hull and crossbar assembly