Hotpoint WD72 - Manual (Page 7)

Choosing a Drying Programme
Independent Drying Programme
IMPORTANT INFORMATION: Before selecting an independent drying programme, ensure the mains button is in the ‘OFF’ position.
DRYING WEIGHT
LOADS
Two examples of typi-
cal loads for drying dif-
ferent types of fabric:
1 Bath Towel
3 Shirts
3 Blouses
1
Set of Pyjamas
2 Sets of Underwear
1 Pillow Case
COTTON
= 2.5kg
2 Children’s
Dresses
2 Shirts
4 Blouses
1
Set of Pyjamas
SYNTHETIC
= 2kg
Items Not Suitable
for Tumble Drying:
● Garments with the ITCL
code -
DO NOT TUMBLE DRY.
● Woollens.
● Large bulky items eg.
quilts, bedspreads,
pillows etc... expand
when dry, preventing air
flow through the
appliance.
● Items containing plastic
film, foam rubber or
rubber like materials eg.
pillows, cushions, PVC
rainwear or inflammable
articles which contain
inflammable substances
eg. towels contaminated
with hair lacquer.
● Fibreglass (eg. some
types of curtains).
● Items which have been
dry cleaned.
Fabric
Type
Programme Dry Weight
Load
Programme
Selector Setting
Time Setting
(approx.mins)
Natural B,C,D & E
F,G & H
2.5kg max. 55
35 High
High Long
Long
Low
Low Short
Short 80
45
80
50
90
60 2kg max. Synthetic
SPIN HEAT IRON DRY FULL DRY
IMPORTANT INFORMATION: A 10 minute ‘Cool Tumble’ phase at the end of
each drying cycle allows fabrics to gently cool down, minimising creasing.
All fabrics contain a little natural moisture even when ‘dry’, this should not
be lost if the clothes are to remain soft and fluffy. If clothes are subjected
to extreme drying they tend to wrinkle and consequently need more
ironing than usual. As clothes feel damper when warm, allow for this
when removing items before the ‘Cool Tumble’ phase is complete.
This machine incorporates a ‘Dry Spin’ feature, see Automatic Features.
Select optional wash &
dry features (STEP 5),
you will hear a beep
and the Infobubble™
will display the
selection. Switch ‘ON’.
The Infobubble™ will
display ’Select
Programme’ Remove the wet
laundry and
dosing ball (if
used) until the
correct ‘Drying
Weight Load’ is
left in the drum.
Close door by
applying pressure at
the 2 o’clock position. Press ‘START’, the door
will lock and the
symbol will appear in
the Infobubble™
throughout the wash
& dry programme. 1-2 minutes after
completion of the
wash programme
the symbol will
disappear and the
door can be opened.
Switch ‘OFF’ after
use.
● If your appliance is not permanently
plumbed in, turn on the cold water supply
to the appliance and hook the drain hose
over the sink to enable to condensing
action to work.
● The dryer is intended
for use only where
water is used for the
cleaning process.
● Be careful not to
touch the drum at
the top as this area
gets hot during
drying.
● On no account
should liquid fabric
conditioner be
added during the
drying process.
● Misuse of the
dryer may create
a fire hazard.
WARNINGS:
1 2 3 4 5 6
STEP 6