Hotpoint WD72 - Manual (Page 11)

Getting to Know your Appliance
Automatic Features:
RED line indicates the minimum
height for the drainage hose.
Hot Water inlet point and supplied
Hose (Red or Grey end)
Cold Water inlet point and supplied
Hose (Blue end)
Mains On/Off Button
Infobubble™ Display
Start, Buzzer/Time Delay
Button
Cancel Button
Optional Wash/Dry Feature
Button
Wash Programme Buttons
Door Handle &
Release Button
Rating Plate
Mains Cable
Drainage Hose
Retaining Flaps
Hooked End Support
Dispenser Drawer
Adjustable Feet
Key Contacts
After Sales Service
Over 1200 trained specialists, directly employed by us, ensure that
you can have complete confidence in both the appliances and
services we offer.
Repair Service and Information Desk
UK: 08709 066 066
(Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays)
www.theservicecentre.co.uk
Republic of Ireland: 1850 302 200
Note: Our operators will require the Model number and Serial number.
Extended Warranties
UK: 08709 088 088
(Open 8 to 8 Mon - Sun)
www.theservicecentre.co.uk
Republic of Ireland: 1850 502 200
Genuine Parts and Accessories
UK: 08709 077 077
(Open 8-30 to 5-30 Mon - Fri & 9 to 12 Sat)
www.theservicecentre.co.uk
Republic of Ireland: (01) 842 6836
Intelligent Care:
Takes care of your laundry by monitoring your machine’s performance.
Prevents your machine spinning with an uneven load and reports any
specific problems on the Infobubble™ display.
Temperature Sensed Fill:
Makes the best use of the existing hot water supply, saving energy,
time and money.
Auto Creasecare:
Reduces creasing on any wash programme by gradually reducing the
water temperature towards the end of the wash programme.
Profile Spin:
Less water, less creasing and less ironing. Gradually steps up the spin
speed for the most efficient water extraction.
Pulse Spin:
Reduces wear and tear on your laundry. A long, steady spin is
followed by a 30 second burst at the maximum speed for your
machine, to enable safer, more efficient water extraction.
Dry Spin:
There will be a 2 minute spin about 20 minutes after the drying
programme has started; this improves the drying performance.
NOTE: This feature will not operate if you have selected a combined Wash
& Auto Dry Programme for synthetic fabrics.
Infobubble™ Display:
The Infobubble™ displays your selected wash programme, optional
wash features selected and shows you exactly where you are in the
washing cycle.
Cleaning the Exterior:
Use a damp cloth or silicon polish to clean the exterior surfaces of the
appliance.
Maintenance Wash:
We recommend a maintenance wash 2 or 3 times a year, to avoid a build
up of greasy deposits and water hardness residue.
Simply run wash programme ‘C’ without any laundry in the drum, using
the usual amount of detergent.
Cleaning the Door Bowl:
Clean the internal surface of the door bowl regularly with a soft cloth.
A build up of soap powder and water hardness residue may result in
water leaking from the door.
DO NOT clean any part of the machine with abrasive cleaners, scouring
agents, acids, chlorine based bleach or metal polish as they may cause
damage.