Hunter Fan ELLIPSE 90063 - Manual (Page 7)

0 A17
H
A18
I
A20 A19
H
A21
ON
OFF
A22
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
Secure the motor by tightening the 2 screws.
Test the motor. If the motor does not run, check the plug
connection.
Turn on the power source.
Connect 4” duct and vent to the outside. Tape joints.
If ducting does not fit securely, an adapter may need
to be purchased.
Connect wiring from the motor to the wiring cover plate.
7 41722-01 3/29/2006 41722-01 3/29/2006
41722_EngS_3.29.03.indd 7 3/29/06 10:54:51 PM