Harbor Freight Tools 35561 - Manual (Page 7)

7. NOTE: The propane tank used must be constructed and marked in accordance
with the specifications for LP propane cylinders by the U.S. Department of
Transportation. (See Figure A.)
8. To connect to the propane tank, first make sure the Temperature Control Knob
(4) of the Propane Stove is in its “OFF” position. Wrap the male threads of the
propane tank’s discharge pipe with about 4 inches of pipe thread seal tape.
Then, screw the Gas Valve of the LP Regulator & Hose Kit firmly onto the propane
tank’s discharge pipe (wrench tighten). (See Figure A.)
OPERATING INSTRUCTIONS
1. CAUTION! Always use clean equipment and utensils. Before using the
Propane Stove, and after using this product, clean all parts in warm, clean water
and anti-bacterial soap. Then, thoroughly dry.
2. NOTE: Higher altitudes may affect cooking efficiency of the Propane Stove.
3. Make sure the Propane Stove and propane tank are located on a clean, dry,
level surface capable of supporting the weight of the Stove and propane
tank. Keep the Propane Stove and propane tank away from other flammable
objects.
4. Check to make sure the Temperature Control Knob (4) on the Propane Stove is
in its “OFF” position. Open the gas valve on the propane tank and check and
smell for gas leaks. Perform a bubble test by applying warm soapy water over
every joint, regulator, fitting, and anywhere else there may be a possible leak.
Observe carefully to see if bubbles expand, indicating a leak. A large leak can
blow the soapy solution away instead of forming bubbles. If leaks are found, do
not use the Propane Stove until the leaks have been stopped. After testing,
make sure to close the gas valve on the propane tank.
5. For manual ignition models, open the gas valve on the propane tank. Apply a
lighted match to the Burner (2) which is to be lit. Next, push the Temperature
Control Knob (4) and turn it to its “ON” position. Once the Burner is lit, safely
dispose of the match and adjust the Temperature Control Knob to the desired
setting. (See Assy. Diagram.)
6. For Piezo Electric ignition models, a Burner (2) can be lit by pushing and turning
the Temperature Control Knob (4) to its “ON” position without having to use a
match. Once the Burner is lit, adjust the Temperature Control Knob to the desired
setting. NOTE: If the Burner does not light up, turn the Temperature Control Knob
to its “OFF” position and wait 5 minutes before trying again.
(See Assy. Diagram.)
SKU For technical questions, please call 1-800-444-3353 PAGE 7
35558
35559
35560
35561