Harbor Freight Tools 35561 - Manual (Page 6)

SKU For technical questions, please call 1-800-444-3353 PAGE 6
GAS VALVE
PROPANE TANK
(NOT INCLUDED)
TEMPERATURE
CONTROL KNOB
(4)
INLET
CONNECTION
NOZZLE
(5)
HOSE
CONNECTOR
MODEL 91357 OR MODEL 91359
LP REGULATOR & HOSE KIT
(NOT INCLUDED)
FIGURE A
ASSEMBLY INSTRUCTIONS
1. WARNING! Always make sure to close the valve on the propane tank
(not included) prior to assembling the Propane Stove, performing maintenance, or
making any adjustments to the unit.
2. CAUTION! This product is machine manufactured . Be aware of sharp
edges. Use heavy duty work gloves and ANSI approved safety impact eye
goggles when assembling.
3. Turn the Propane Stove upside down, and attach a Rubber Foot (7) to each
corner of the unit. (See Assy. Diagram.)
4. For double-burner models only, the Temperature Control Knobs (4) must be
attached. To do so, loosen the counter-sunk Screw in the Knob. Insert the Knob
onto the Burner Control Shaft by aligning the flat edges of the Knob and Shaft.
Then, firmly tighten the Screw. (See Assy. Diagram.)
WARNING: The Propane Stove requires the attachment and use of the Model
91357 or Model 91359 LP Regulator & Hose Kit (UL
® Listed) which are sold
separately by Harbor Freight Tools. (See Figure A.)
5. To attach the Model 91357 or Model 91359 LP Regulator & Hose Kit to the
Propane Stove, remove the plastic protective cap from the Inlet Connection
Nozzle (5) on the Propane Stove. Next, wrap the male threads of the Inlet
Connection Nozzle with about 4 inches of pipe thread seal tape (not included).
Then, screw the Hose Connector firmly onto the Inlet Connection Nozzle.
(See Figure A.)
35558
35559
35560
35561
caution are factors which cannot be built into this product, but must be supplied
by the operator.