Horizon Fitness T901 - Manual (Page 7)

12
INTR
ODUC
TION
IMPOR
TANT
PRE
CA
UTIONS
BEF
ORE
YOU
BE
GIN
TREADMILL OPER
ATION
LIMITED
W
ARR
ANTY
TR
OUBLE
SHOO
TING
&
MAINTENANCE
CONDITIONING
GUIDELINE
S
AS
SEMBL
Y
BEF
ORE
YOU
BE
GIN
AS
SEMBL
Y
1
INTR
ODUC
TION
IMPOR
TANT
PRE
CA
UTIONS
TREADMILL OPER
ATION
CONDITIONING GUIDELINE
S
TR
OUBLE
SHOO
TING
&
MAINTENANCE
LIMITED
W
ARR
ANTY
ASSEMBLY STEP
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (K)
CONSOLE
HANDLEBAR BRACKET
RIGHT SIDE:
CONNECT CONSOLE
CABLES, PULSE CABLES
AND POWER CABLES
LEFT SIDE:
CONNECT PULSE
CABLES ONLY
FLAT WASHER (B)
8 mm
Qty: 4 SPRING WASHER (C)
8 mm
Qty: 4 BOLT (K)
20 mm
Qty: 4
HARDWARE BAG CONTENTS:
Open HARDWARE BAG .
Place CONSOLE onto HANDLEBAR
BRACKETS as shown.
NOTE: Do not pinch CONSOLE CABLE
when placing the console onto the
handlebar brackets.
Insert 2 BOLTS (K), 2 SPRING
WASHERS (C) and 2 FLAT WASHERS
(B) through the bottom of the
HANDLEBAR BRACKET to secure the
console to the HANDLEBAR BRACKET.
Repeat on other side.
Reach inside the right underside of
the console to pull out the CONSOLE
CABLE, PULSE CABLE and POWER
CABLE. Attach to the matching cables
that are hanging out of the cable hole
in the handlebar.
Repeat on left side to attach PULSE
CABLE.
Thread attached cables back through
the cable holes when finished.
A
B
C
D
E
F
G
NOTE: Do not completely tighten
any screws or bolts until step 6 is
complete!
ASSEMBLY STEP
CONSOLE
CUP HOLDER
SCREW (P)
SCREWS (O)
Open HARDWARE BAG .
Attache CUP HOLDERS to CONSOLE by inserting 4 SCREWS (O) and 2 SCREWS (P).
A
B
SCREW (O)
15 mm
Qty: 4 SCREW (P)
30 mm
Qty: 2
HARDWARE BAG CONTENTS:
NOTE: Assembly of cup holders may be easier if console is flipped upside down before inserting
screws. Be careful not to overtighten screws.
T901_Rev.2.0.indd 12-13 9/10/08 11:15:40 AM