Harbor Freight Tools DRILL MASTER 96526 - Manual (Page 14)

Page 14 SKU 96526 For technical questions, please call 1-800-444-3353.
The Drill/Driver has a variable speed for drilling. To vary the speed of the drilling
action, vary the pressure on the Power Switch (10).
Drill only as deep as is necessary. Do not drill deeper than necessary into walls
or other areas where you cannot identify any possible hazards behind the drilling
surface.
To reduce jamming as the drill bit breaks through the workpiece, decrease the
drilling pressure when the point of the drill bit breaks through the surface of the
workpiece.
When you have drilled the hole, remove the drill bit from the hole while the Drill/
Driver is still rotating. This prevents the drill bit from getting caught in the hole
and causing damage.
Release the Power Switch (10) to stop the Drill/Driver.
InSpECtIOn, MAIntEnAnCE, AnD CLEAnIng
Risk of serious personal injury from accidental starting
or electric shock. turn the power Switch of the tool to its
“OFF” position and unplug the tool from its electrical outlet
before performing any inspection, maintenance, or cleaning
procedures.
Damaged equipment can fail, causing serious personal
injury. Do not use damaged equipment. If abnormal noise or
vibration occurs, have the problem corrected before further
use.
CAutIOn! Always disconnect the Battery (29) from the tool before performing
and inspection, maintenance, or cleaning.
Before each use, examine the general condition of the Drill/Driver. Check for
loose screws, misalignment or binding of moving parts, broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation. Run
the Drill/Driver for about ten seconds to ensure all moving parts are running
smoothly and there are no loose parts, rattles, or sparking that would indicate
defects. if a problem occurs, turn off the Drill/Driver immediately and have the
problem corrected before further use. Do not use a damaged tool.
the Drill/Driver is equipped with a 24V nickel-Cadmium Battery (type:
1300 mAh ni-Cd Rechargeable). With proper care, the Battery (29) can be
recharged many, many times. Follow the Steps below to ensure proper Battery
care:
Always switch to a fresh Battery when tool performance begins to diminish.
Severe heat is most destructive to a Battery. The more heat generated, the
10.
11.
12.
13.
14.
1.
2.
3.
•
WARnIng WARnIng