Harbor Freight Tools 65673 - Manual (Page 8)

SKU 65673 For technical questions, please call 1-800-444-3353. Page 8
dition. Always replace a damaged
extension cord or have it repaired by
a qualified electrician before using it.
Protect the extension cords from
8.
sharp objects, excessive heat, and
damp or wet areas.
recommended minimum Wire
gauge For eXtenSion cordS*
(120/240 Volt)
namePlate
amPereS
(at full load)
eXtenSion cord
lengtH
25’ 50’ 75’
100’ 150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
taBle a
* Based on limiting the line
voltage drop to five volts at
150% of the rated amperes.
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
a
Amperes
n0 xxxx/min.
No Load Revolutions per Minute
(RPM)
SPeciFicationS
Motor Speed 20,000 RPM
Cutter Head Speed 10,000 RPM
Input
120 V~ / 60 Hz /
4.5 A (no load)
Cutting Knives 2
Maximum Planing Width 3.937”
Maximum Cutting Depth .078”
Fence Tilt 90-135 degrees
unPacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Examine the machine work surface
to make certain it is clear of grease and
debris.
aSSemBlY
read the entire imPortant
SaFetY inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
to PreVent
SeriouS inJurY
From accidental
oPeration:
turn the Power Switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
reV 09g