Harbor Freight Tools 65673 - Manual (Page 11)

SKU 65673 For technical questions, please call 1-800-444-3353. Page 11
There must not be hazardous ob- 3.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
general operating instructions
The Jointer Planer has a Key which 1.
fits into the On/Off Switch. Plug the
Jointer Planer into a standard 120V
outlet.
Make certain Key is in Switch. Press
2.
to On position.
caution:
3. Use the push block with
every operation and when working
with stock that is less than 3” wide or
thick.
caution:
4. Never feed with your
hand on the end of the stock! Serious
injury may result.
Always hold your stock firmly against
5.
the fence.
Always feed at an even rate along the
6.
entire length. Stopping will result in
marred and uneven finishes. Do not
feed too fast.
Apply even pressure. Start feeding
7.
with your left hand forward and your
right a couple inches behind. As your
right hand passes over the blades,
move your left hand behind the right.
Continue shifting in this fashion until
all of your stock has been planed.
For Bevel Planing: Set the fence to 8.
the desired angle by using the Angle
Scale (81). See Figure 3, below.
Move the fence in or out along the 9.
table to accommodate the desired
planing width. Plane along the edge
of the stock. Make sure you are push-
ing the sock firmly against the fence.
To prevent accidents, turn off the
10.
tool and disconnect its power supply
after use. Remove Key from On/Off
switch and store in a safe location out
of the reach of children. Clean, then
store the tool indoors out of children’s
reach.
Figure 3
Angle Scale (81)
Fence (76)