Harbor Freight Tools 65673 - Manual (Page 4)

SKU 65673 For technical questions, please call 1-800-444-3353. Page 4
do not use the power tool if the b.
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
disconnect the plug from the
c.
power source before making any
adjustments, changing accesso-
ries, or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool ac-
cidentally.
Store idle power tools out of the
d.
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper-
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
maintain power tools. check for
e.
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool’s operation. if dam-
aged, have the power tool repaired
before use. Many accidents are
caused by poorly maintained power
tools.
Keep cutting tools sharp and
f.
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
use the power tool, accessories
g.
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result
in a hazardous situation.
Service 6.
Have your power tool serviced by a.
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
4” Jointer Planer Safety Warnings
cutter heads must be rated for at 1.
least the speed recommended on
the tool. Cutter heads running over
rated speed can fly apart and cause
injury.
Do not perform jointing or planing
2.
with cutter block assembly or drive
guard removed.
Do not make cuts deeper than 1/8”.
3.
Always use a push block. 4.
Always inspect workpiece to make 5.
certain it is free from nails or other
foreign objects which may break or
damage the blade.
Feed the work piece into the blade
6.
against its rotation only.
Do not start the machine under load.
7.
Allow Jointer Planer to attain full
speed before engaging stock to the
blade.
Make certain stock is supported at all
8.
times during operation.
Do not use blunt or damaged cutter
9.
heads.
Always check the proper working of
10.
the guard retracting system before
each use.
Maintain labels and nameplates on
11.
the tool. These carry important safety
information. If unreadable or miss-