Removing the snowblower – HONDA SB 2040 User Manual

Page 31

Removing the Snowblower SB2040

Snowblower

Removing the Snowblower

Make sure the PTO clutch lever is OFF.

Drive the lawn tractor to a flat, level surface, turn the engine

off, remove the ignition key and set the

parking brake ON. Disconnect the spark plug cap. Lower the height adjustment lever all the way down.

Raise the front tires and support them squarely on top of

two 4 x 4" blocks of wood.

DRIVE BELT

SILVER

Remove the silver-colored bolt that holds the

engine pulley belt guard to the right side of the
lawn tractor frame. Allow the belt guard to fall
down slightly, then remove the snowblower
drive belt from the engine pulley.

BELT GUARD

PIVOT PLATE ON
U-SHAPED BRACKET

Loosen the jam nut on the belt tension

FRONT

turnbuckle, then lengthen the turnbuckle

enough to disconnect the J-bolt from the

PTO

pivot plate.

LOOSEN JAM NUT

REMOVE HOOK BOLT

6. Remove the 2 x 40 mm spring clip and two flat

washers from the PTO connecting rod where it

is connected to the PTO pivot plate. Allow the
rod to fall clear from the pivot plate. Retain the
spring clip and washers when reinstalling the
snowblower or the mower deck.

FLAT WASHER

(2)

and

2 x 2 6 m m

SPRING CLIP

POP

52152 (9610)

This manual is related to the following products:

H2013