Operating the snowblower, Snow removal methods – HONDA SB 2040 User Manual
Page 29
Safety Recommendations SB2040 Snowblower
Operating the Snowblower
Read the lawn tractor owner's manual carefully.
Be thoroughly familiar with the controls and
proper use of the lawn tractor. Know how to
stop the lawn tractor and disengage the
controls quickly.
Never allow children to operate the
snowblower. Never allow adults to operate the
snowblower without proper instruction.
Do no allow anyone other than the operator on
the lawn tractor.
Keep the area of operation clear of all people
and pets.
Clothing worn by the operator should be fairly
tight and belted. Loose clothing should not be
permitted because
of
the danger of getting into
moving parts.
Tie up or restrain long hair.
1.
Start the lawn tractor. After the engine has warmed for at least a minute, move the throttle to
2.
Verify that the blower head is properly positioned, then move the PTO clutch lever to ON.
3. Adjust the ground speed of the lawn tractor as needed. Use the shift lever to change ground speeds,
(FAST).
never the throttle. For best performance, the throttle should always be set to
(FAST).
Snow Removal Methods
Use the following patterns to avoid discharging snow in
unwanted locations and to prevent a second pass. For
clarity, assume both methods are used on a rectangular
area.
If you can discharge snow to both sides, it is best to
start in the middle of the rectangle. Operate the
snowblower from one end to the other, discharging
snow to both sides. This method permits you to leave
the discharge chute in the same position.
If you must discharge snow to only one side, start in
one corner, then rotate the discharge chute with each
pass. This method will require a bit more effort, but the
snow will be discharge only to one side.
OKAY
TO DISCHARGE SNOW TO THIS SIDE
FINISH HERE
OKAY TO
DISCHARGE SNOW TO
SIDE
START HERE
ROTATE
FINISH HERE
DISCHARGE
SNOW TO THIS
SIDE ONLY
28
POP
521 52 (961 0)